Green Wheel Replacement for Pedal Cars: A How-To Guide
By Vintage Pedal Cars and Ride-Ons for Children - Baghera | Published: 2026-10-28
Category: How-to Guides
Learn how to replace a green 25cm wheel on a Baghera pedal car. Step-by-step instructions to swap a worn wheel and keep your ride-on rolling smoothly.
Quick answer
Replacing a green 25cm wheel on a Baghera pedal car is straightforward: remove the retaining clip and axle, slide off the old wheel, and install the new one. This guide walks you through each step to get the job done safely.
Why replace a green wheel?
Green 25cm wheels are common on several Baghera ride-on models. Over time, the rubber tire can wear down or the plastic hub may crack from regular use. Replacing a damaged wheel restores smooth rolling and prevents further wear to the axle or steering components.
Before starting, confirm the wheel diameter and color match your model. Baghera uses specific color codes for different series, so a green 25cm wheel may not be compatible with a red or blue axle assembly.
Tools you will need
You likely already have the tools at home: a flat-head screwdriver or small pry tool to remove the retaining clip, a hammer (optional) to tap the axle out if stuck, and a clean rag to wipe the axle before installing the new wheel.
Step-by-step wheel replacement
- 1. Remove the retaining clip: Locate the small metal retaining clip on the axle, usually near the wheel hub. Use a flat-head screwdriver to gently pry it off. Keep the clip in a safe place—you will reuse it. Do not bend the clip; a bent clip may not hold the wheel securely.
- 2. Slide off the old wheel: Pull the wheel straight off the axle. If it is stuck, tap the axle end lightly with a hammer while pulling the wheel. Wipe the axle clean with a rag to remove dirt or rust. Check the axle for bends or rust; a damaged axle should be replaced before installing the new wheel.
- 3. Install the new green wheel: Align the wheel hub with the axle and slide it on until it sits flush against the frame. Reattach the retaining clip by pressing it into the groove on the axle. Ensure the clip is fully seated. Spin the wheel after installation—it should rotate freely without wobbling. If it binds, the clip may not be fully seated or the wheel is not aligned.
Product facts
- Metal steering wheel - Rider: The Metal steering wheel - Rider is a Baghera spare part designed for ride-on vehicles, listed under Pièces Détachées. While this guide focuses on wheel replacement, the same spare-parts category includes other replacement components like steering wheels, so you can find matching parts for your Baghera model.
Metal steering wheel - Rider
