How to Install a Horn on a Baghera Ride-On
By Vintage Pedal Cars and Ride-Ons for Children - Baghera | Published: 2026-10-18
Category: How-to Guides
Learn to attach the vintage Baghera horn to your child's pedal car. Simple steps, no tools required, plus a common fitting mistake to avoid.
Quick answer
Mount the Baghera horn by sliding it onto the steering column tube and tightening the included screw. No tools are needed, but you must align the horn's slot with the column's flat side to avoid a loose fit.
Why add a horn to a Baghera pedal car?
A horn is a simple way to add sound and play value to a ride-on. The Baghera horn is designed to match the vintage look of the cars and fits most models with a standard steering column. It also gives children a way to signal their arrival, which adds to the imaginative play experience.
Step-by-step installation
- 1. Locate the steering column: Find the vertical metal tube that connects the steering wheel to the front axle. The horn mounts directly onto this tube, just below the steering wheel. Check that the column is clean and free of debris before fitting the horn.
- 2. Align the horn's slot with the column flat: The horn has a small notch on its inner ring. The steering column has a flat side. Rotate the horn so the notch aligns with this flat side; otherwise the horn will not sit flush and may wobble. A common mistake is forcing the horn on without aligning the notch. This can strip the plastic or leave the horn loose.
- 3. Slide the horn onto the column: Push the horn downward until it rests against the stop ring near the base of the steering wheel. It should fit snugly without excessive force. If the horn does not slide easily, recheck the alignment. Do not hammer or force it.
- 4. Tighten the set screw: The horn includes a small Phillips-head screw on its side. Turn it clockwise by hand until it presses against the column. Do not overtighten—snug is sufficient to hold the horn in place. Overtightening can crack the horn's plastic housing. A quarter turn past hand-tight is enough.
- 5. Test the fit and sound: Gently wiggle the horn to confirm it is secure. Press the rubber bulb to test the sound. If the horn shifts, loosen the screw, realign, and tighten again. The horn is a press-fit accessory; it may rotate slightly during play. That is normal and does not affect function.
Product facts
- Horn: Our vintage horn will look great on our Baghera pedal cars. To announce its arrival or just for fun, it's an accessory that will surely delight the little ones! The horn is purely decorative and sound-producing; it does not affect steering or safety. Its classic design complements the retro styling of Baghera cars.
Horn
