Hardware Set for Speedsters: Installation Guide

By Vintage Pedal Cars and Ride-Ons for Children - Baghera | Published: 2026-10-20

Category: How-to Guides

Step-by-step instructions for installing the Baghera Hardware set for Speedsters. Learn how to replace worn parts and keep your ride-on safe and fun.

Quick answer

Installing a Baghera Hardware set for Speedsters takes about 20 minutes with basic tools. Follow the steps below to replace worn hardware and avoid stripping threads or losing small parts.

What the hardware set includes

The Hardware set for Speedsters (reference 1752) contains replacement bolts, washers, nuts, and spacers designed specifically for Baghera Speedster ride-ons. It does not include tools or decorative parts like steering wheels or pedals. If you are missing those, order them separately.

When to replace the hardware

Over time, hardware can loosen, rust, or strip. Replace the set if you notice wobbling in the steering or pedals, or if any bolt feels loose after tightening. Using the correct Baghera spare parts ensures a proper fit and avoids damaging the frame.

Installation steps

Gather your tools and workspace: You will need a Phillips-head screwdriver, a small adjustable wrench, and a clean, flat surface. Lay out the hardware set contents and identify each piece using the included diagram. Do not start without the diagram. It shows which washer or spacer goes where.
Remove the old hardware: Using the screwdriver and wrench, carefully unscrew and remove all existing bolts, nuts, and washers from the Speedster. Keep the frame components (steering bar, pedal arms, axle brackets) in place. Work over a tray to catch falling nuts and bolts. Reusing old hardware is not recommended; discard them.
Install the new hardware in order: Insert each bolt through the corresponding hole, add the correct washer and spacer as shown in the diagram, then thread the nut on the opposite side. Tighten firmly by hand first, then use the wrench for a final snug fit. Do not overtighten – you can strip the threads or crack the plastic frame. Snug is enough.
Check all moving parts: After all hardware is installed, test the steering and pedals by moving them through their full range of motion. Ensure there is no binding or excessive play. Tighten any loose bolts slightly. If a joint still wobbles after tightening, you may have missed a spacer or used the wrong washer. Double-check the diagram.
Perform a safety check: Place the Speedster on a flat surface and apply pressure to the seat and pedals. Confirm that all hardware remains tight and no sharp edges are exposed. Let your child ride only after you have verified everything is secure. Recheck all bolts after the first few rides, as new hardware can settle and require a minor adjustment.

Product details

Hardware set for Speedsters: The Hardware set for Speedsters is a Baghera spare-parts item intended for use with Speedsters ride-ons. It is offered under the reference code 1752 in the Standard option. This set is not universal; it fits only Baghera Speedsters. Using generic hardware may not align with the pre-drilled holes or thread sizes.
Hardware set for Speedsters